TCMT16T308-MF2 CP500 Triangular Turning Insert Single Sided With Centre Hole 1841250 34mm and Ø3

34mm and Ø3

85mm (2-7/32"-2-3/4")

5 x 34mm cross section

launch control or it could be used as a Valet Mode

Body Width (in): 9

TCMT16T308-MF2 CP500 Triangular Turning Insert Single Sided With Centre Hole 1841250 34mm and Ø3CP500 Grade: Tough micrograin grade intended for finishing to medium roughing of stainless steels but with wide applicability for example in steels and aluminium alloys. Especially suitable in intermittent cuts. (Ti,Al)N + TiN p>MF2 Chipbreaker: First choice for finishing with negative inserts. Suitable for chip control at depths of cut down to 0,25 mm, provided that the feed rate is in excess of 0,25 mm rev. Good capacity for medium rough machining.